Bartec MC 9090ex-S Bedienungsanleitung PDF herunterladen (Seite 65)

Supplement for EDGE/GPRS

3.4 EDGE / GPRS

3.4.1 Safety on the Road

Do not take notes or use the device while driving. Jotting down a “to do” list or flipping through your address book takes

attention away from your primary responsibility, driving safely. When driving a car, driving is your first responsibility - Give

full attention to driving. Check the laws and regulations on the use of wireless devices in the areas where you drive. Always

obey them. When using a wireless device behind the wheel of a car, practice good common sense and remember the

following tips:

■ Get to know your wireless device and any features such as speed dial and redial. If available, these

features help you to place your call without taking your attention off the road.

■ When available, use a hands free device.

■ Let the person you are speaking with know you are driving; if necessary, suspend the call in heavy traffic

or hazardous weather conditions. Rain, sleet, snow, ice, and even heavy traffic can be hazardous.

■ Dial sensibly and assess the traffic; if possible, place calls when you are not moving or before pulling

into traffic. Try to plan calls when your car will be stationary. If you need to make a call while moving, dial

only a few numbers, check the road and your mirrors, then continue.

The wireless industry reminds you to use your device / phone safely when driving.

5. Commissioning

5.1 Installation of the SIM Card

The insertion of the SIM card and the use of the MC 9094

as a telephone are described in the original Motorola manual

(User Guide). See Chapter 8.1 for the link to the User Guide.

Motorola Manual (User Guide)

- Chapter 1 Getting Started SIM Card (Installation of the SIM card)

- Chapter 4 MC9094 Phone (Operation of the MC9094 as a telephone)

Note that the SIM card may only be inserted or replaced in a non-hazardous area. Care must be taken also that the

tightening torque is adhered to when closing the SIM door.

Tighten the screws (torque = 0.34 Nm / torque = 3.0 in-lbs) 0.3 Nm advisable

Caution: The torque must be adhered to!

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 71 72

Keine Kommentare

Bartec MC 9090ex-S Bedienungsanleitung Seite 65